Zur deutschen Version wechseln

## Problems for the 13thAYPT - Remarks

Note: According to the Regulations of the AYPT the problems for the AYPT are the same as for the IYPT.

## Problems for the 13thAYPT 2011

Determine the force necessary to remove a piece of adhesive tape from a horizontal surface. Investigate the influence of relevant parameters.

### 2. Air drying

Table utensils (dishes, cutlery, etc.), after being washed, dry differently. Investigate how the time of drying depends on relevant parameters.

### 3. Bouncing flame

Place a flame (e.g. from a Bunsen burner) between two charged parallel metal plates. Investigate the motion of the flame.

### 4. Breaking spaghetti

Find the conditions under which dry spaghetti falling on a hard floor does not break.

### 5. Car

Build a model car powered by an engine using an elastic air-filled toy-balloon as the energy source. Determine how the distance travelled by the car depends on relevant parameters and maximize the efficiency of the car.

### 6. Convection

In a container filled with a liquid, heat transport will occur when the bottom of the container is heated and the top surface is cooled. How does the phenomenon change when the container rotates about its vertical axis?

### 7. Cup drum

A plastic cup is held upside-down and tapped on its base. Investigate the sound produced when the open end of the cup is above, on or below a water surface.

### 8. Domino amplifier

A row of dominoes falling in sequence after the first is displaced is a well known phenomenon. If a row of "dominoes" gradually increases in height, investigate how the energy transfer takes place and determine any limitations to the size of the dominoes.

### 9. Escaping powder

When a hot wire is plunged into a beaker of water with powder (e.g. lycopodium) floating on the surface, the powder moves rapidly. Investigate the parameters that alter the speed of movement of the powder.

When a container filled with small spheres (e.g. mustard seeds) is vibrated vertically with a frequency between 1 – 10 Hz, so called Faraday heaping occurs. Explore this phenomenon.

### 11. Fingerprints

Fill a glass with a liquid and hold it in your hands. If you look from above at the inner walls of the glass, you will notice that the only thing visible through the walls is a very bright and clear image of patterns on your fingertips. Study and explain this phenomenon.

### 12. Levitating spinner

A toy consists of a magnetic spinning top and a plate containing magnets (e.g. "Levitron"). The top may levitate above the magnetic plate. Under what conditions can one observe the phenomenon?

### 13. Light bulb

What is the ratio between the thermal energy and light energy emitted from a small electric bulb depending on the voltage applied to a bulb?

### 14. Moving cylinder

Place a sheet of paper on a horizontal table and put a cylindrical object (e.g. a pencil) on the paper. Pull the paper out. Observe and investigate the motion of the cylinder until it comes to rest.

### 15. Slow descent

Design and make a device, using one sheet of A4 80 gram per m2 paper that will take the longest possible time to fall to the ground through a vertical distance of 2.5m. A small amount of glue may be used. Investigate the influence of the relevant parameters.

### 16. Smoke stream

A glass jar is covered with cellophane. A tightly folded paper tube of length 4-5 cm is inserted hermetically into the jar through the cellophane cover. The tube is oriented horizontally. If one burns the outside end of the tube the dense smoke flows into the jar. Explore this phenomenon.

### 17. Vikings

According to a legend, Vikings were able to navigate in an ocean even during overcast (dull) weather using tourmaline crystals. Study how it is possible to navigate using a polarizing material. What is the accuracy of the method?

## News

### 2016-01-03 — AYPT 2016

General information on, the invitation to and the preliminary schedule of the 18 th Austrian Young Physicists' Tournament 2016 are available now as well as some changes in the regulations !!

More...

### 2015-10-05 — General Assembly 2015

The General Assembly 2015 will take place on November 28, 2015.

More...

### 2015-07-09 — Problems for 2016

The Problems for 2016 can be found here .

More...