Zur deutschen Version wechseln

and

## Problems for the 5thAYPT, May 2nd to May 4th 2003, Vienna, Austria

### 1. Motion of a kite

On windy days one can see kites flying in the wind. Often, one-string kites move on a stable track, which looks like a number 8. Why does a kite move in such a way? Are there other stable tracks?

### 2. Water drops

Investigate and explain the movement of raindrops on a window pane.

### 3. Transparent film

If you cover printed text with a piece of transparent polyethylene film you can still easily read it. As you gradually lift up the film, the text becomes increasingly blurred and may even disappear. Study the properties of the film. On what parameters of the film is the phenomenon based?

### 4. Bright spots

Blow a soap bubble and allow it to rest on a liquid surface or a glass plate. When illuminated by sunlight, bright spots can be observed on the bubble. Investigate and explain the phenomenon.

### 5. Bubbles at an interface

Certain liquids can be layered one above the other with a sharp interface between them. If the surface tensions of the liquids are different, then an interesting phenomenon can be observed. Blow bubbles of different sizes into the lower liquid and observe their behaviour near the interface. Investigate and explain the phenomenon.

### 6. Freezing soft drinks

On opening a container of cold soft (carbonated) drink the liquid inside sometimes freezes. Study the relevant parameters and explain the phenomenon.

### 7. Oscillating box

Take a box and divide it into a number of small cells with low walls. Distribute some small steel balls between the cells. When the box is made to oscillate vertically, the balls occasionally jump from one cell to another. Depending on the frequency and the amplitude of the oscillation, the distribution of the balls can become stable or unstable. Study this effect and use a model to explain it.

### 8. Heat engine

Construct a heat engine from a U-tube partially filled with water (or another liquid), where one arm of the tube is connected to a heated gas reservoir by a length of tubing, and the other arm is left open. Subsequently bringing the liquid out of equilibrium may cause it to oscillate. On what does the frequency of the oscillation depend? Determine the pV diagram of the working gas.

### 9. Falling chimney

When a tall chimney falls it sometimes breaks into two parts before it hits the ground. Investigate and explain this.

### 10. Tungsten lamp

The resistance of the tungsten filament in a light bulb shows temperature dependence. Build and demonstrate a device based on this characteristic.

### 11. Light scattering

Construct an optical device for measuring the concentration of non-soluble material in aqueous colloid systems. Use your device to measure the fat content of milk.

### 12. Boiled egg

Construct a torsion viscometer. Use it to investigate and explain the differences in the 'viscous' properties of hens' eggs that have been boiled to different extents.

### 13. Electro-osmosis

Develop a device that will dram wet sand, with the aid of an electrical voltage but without significant heating.

### 14. Rotating disk

Find the optimum way of throwing a 'frisbee' as far as possible. Explain your findings.

### 15. Vortices

Make a box that has a hole in its front wall and a membrane as its back wall. Hitting the membrane creates a vortex that propagates out from the hole. Investigate the phenomenon and explain what happens when two vortices interact.

### 16. Pot and ice

It is sometimes argued that to cool a pot effectively one should put Ice above it. Estimate to what extent this is more effective than if the Ice is put under the pot.

### 17. Prometheus problem

Describe and demonstrate the physical mechanism, based on friction, which allowed our ancestors to make fire. Estimate the time needed to make fire in this way.

## News

### 2016-01-03 — AYPT 2016

General information on, the invitation to and the preliminary schedule of the 18 th Austrian Young Physicists' Tournament 2016 are available now as well as some changes in the regulations !!

More...

### 2015-10-05 — General Assembly 2015

The General Assembly 2015 will take place on November 28, 2015.

More...

### 2015-07-09 — Problems for 2016

The Problems for 2016 can be found here .

More...